NVC-401D, NVC-401D/IR, NVC-421D
- User’s manual ver. 1.0
All rights reserved © AAT Holding Sp. z o.o.
9
NVC-421D:
Put
mounting drawing paper to the wall or ceiling and mark drill holes.
Drill holes for screws and cables.
Gently unscrew the camera cover counter-clockwise
Remove the masking shield from the camera.
Press the tab, which is located inside the middle-housing, and unscrew the base of the camera.
Using mounting screws from the package attach the base of camera to the ceiling/wall.
Put middle-housing on the base of the camera and screw it clockwise.
Manually point the camera in a desired direction to obtain a desired scene view.
Adjust zoom and focus if needed.
Put the masking shield onto camera. Please ensure that masking shield does not block the field of view of the cam-
era.
Put dome cover on the camera and screw it clockwise.
4.1 Power supply connection
Warning: Device should be supplied only from a power sources whose parameters are
in accordance with those specified by the producer in the camera technical
datasheet. Therefore, it is forbidden to supply the camera from power sources with
their parameters unknown, unstable or not meeting the producer’s requirements.
See the power supply terminal connections below.
NVC-421D camera can be supplied using additional power supply input, inside the
camera cover. It is important to pay attention to polarity of the power supply.
5. SETTINGS
Camera is equipped with an OSD menu. During camera operation, status information can be dis-
played on the screen.
As mentioned before, a joystick is placed inside the camera cover (NVC-421D) or attached to power/
video cable (NVC-401D i NVC-401D/IR), for navigating and changing menu settings:
INSTALLATION
video
12V DC +/- 10%
video
GND
+
- (GND)
ENTER
LEFT
DOWN
UP
SET
RIGHT
