NVC-230C color camera user’s manual, v.1.0
© Copyright 2003, Novus Security Sp. z o.o. All rights reserved.
6
Installation of Auto Iris Lens Connector
Install the lens connector when using a Video drive lens.
The installation should be made by qualified service personnel or system installers
Cut the iris control cable at the edge of the lens connector to remove the existing lens connector and
then remove the outer cable cover of the supplied connector as shown in the diagram.
The pin assignment of the auto iris lens connector is as follows:
VIDEO DC
Pin 1
Power source
Damp
-
Pin 2
Video signal
Damp +
Pin 3
Not used
Pin 4
Ground, Shield
Driver
-
Solder the lens cable to the pins of the supplied connector
Focus or Flange-Back Adjustment
The following adjustment should be made by qualified service personnel or system installers.
1. Mount the lens by turning it clockwise on the lens mount of the camera.
2. Loosen the screws on the flange-back adjusting ring.
3. Turn the flange-back adjusting ring to the desired position.
4. Tighten the screws on the flange-back adjusting ring.
Standard Accessories
Main body *1
HEX wrench *1
C mount adaptor ring * 1
Iris header *1
Instruction manual *1
