NVB-5000WB wall bracket mounting manual ver. 1.0
All rights reserved © AAT Holding sp. z o.o.
4
INSTALLATION
2.
INSTALLATION
In order to successfully mount a camera, please follow the procedure below:
Part I
•
Pick a suitable location and provide all necessary wiring in desired housing mounting place.
•
Mark mounting holes and drill them in selected locations.
•
Screw the mounting box to a wall using for plastic anchors.
•
If required, please seal all the desired holes additionally and threaded
connection (1), by means of appropriate sealing mass.
•
Put the required wiring and power supplies into the box using holes
provided in the box.
Part II
•
Use the included allen key to remove the camera cover dome screws (2) and remove cover dome.
•
Remove the camera base by unscrewing the 3 base locking screws, and turn camera module approx.
5 degrees counterclockwise to detach camera base from the camera module.
Part III
•
Run camera cables through the base of the camera
and wall bracket.
•
Using M4*10 screw, mount the camera to the bracket.
•
Ensure the rubber gasket inside the camera is properly
in place, then mount the camera cover dome and the
camera cover screws.
•
Connect cabling inside the box.
•
Using M4*30 screws, mount the bracket with
attached camera to the mounting box.
1
2
