NVAHD
-
2DN5102MH/IR
-
1
-
ver. 1.2
-
User
’
s manual
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o
8
SETTINGS
4.1. Power supply connection
NOTE: Device should be supplied only from a power sources whose parameters are in
accordance with those specified by producer in the camera
’
s technical datasheet. Therefore, it is
forbidden to supply the camera from power sources whose parameters are unknown, unstable or
not meeting the producer
’
s requirements.
5. SETTINGS
The camera has an OSD menu displayed in the foreground of image. During normal operation status
information can be displayed on the image. To navigate menu and make changes please use
joystick located on the cable of the camera:
To enter the menu, press the joystick, which sends
ENTER
command to the device. To choose
submenu, select the
UP, DOWN (UP, DN)
directions. If the sub
-
menu contains the symbol
that
indicates the opportunity to enter to the settings by pressing the
ENTER
key. To change the parameters
of selected items, press
LEFT, RIGHT
buttons.
To exit the menu and saves changes, select
EXIT
and next
select
SAVE & END
.
By selecting
RESET
you can restore the factory settings, and by selecting
NOT
SAVE
you can exit the menu without saving changes. To exit the submenu, select
RETURN
and press
ENTER
.
Choosing (with left or right button)
SAVE & END
in the
RETURN
position saves changes and
closes the menu.
Camera can also be controlled by COAX protocol used on DVR.
Camera mode settings
Camera got four video 1080p modes: AHD, CVI, TVI and 960h CVBS. Depends on used DVR, user
need to set DIP switches in appropriate position according to the picture below:
Video
(GND)
+
-
(GND)
Power Supply 12V DC +/
-
10%
Video
