NVAHD-2DN5102MD/IR-1 - user’s manual ver. 1.1
All rights reserved © AAT Holding S.A.
8
INSTALLATION
4. INSTALLATION
Please familiarize yourself with the device, its parameters and methods of mounting, before
mounting .
Put mounting drawing paper to the wall or ceiling and mark drill holes.
Drill holes using markings.
Drill additional hole for video and power cables.
Please mount the camera using included screws. Please pay special attention to sealing the
mounting holes with an appropriate sealing mass.
Adjust the position of the camera module.
Unscrew the blocking screws and adjust focal length and focus.
If needed, adjust the desired settings in the camera menu, using function buttons.
Put on the camera bubble again
4.1. Power supply connection
NOTE: Device should be supplied only from a power sources whose parameters are in
accordance with those specified by producer in the camera’s technical datasheet. Therefore, it is
forbidden to supply the camera from power sources whose parameters are unknown, unstable
or not meeting the producer’s requirements.
4.2 Camera mode settings
Camera got four video modes: TVI, AHD, CVBS and CVI. Depends on used DVR. User need to set
DIP switches according to the picture:
zasilanie 12V DC +/- 10%
wideo
wideo
masa (GND)
+
- (GND)
