NVAHD-2DN5100MC-1 version 1.0 - User’s manual
All rights reserved © AAT Holding S.A.
11
SETTINGS
4.2 Power supply connection
Warning: Device should be supplied only from a power sources whose parameters are in accordance
with those specified by the producer in the camera technical datasheet. Therefore, it is
forbidden to supply the camera from power sources with their parameters unknown,
unstable or not meeting the producer’s requirements.
NVAHD-1DN5100MCC-1 is 12VDC ± 10% supplied. Please make sure proper polarity is
maintained.
CAUTION:
In case of the image failure after connecting camera, or video loss due to changes in the menu,
it is possible to restore the factory settings. Following procedure is also recommended when
camera menu is not working. To restore factory settings:
1. Turn the power off and on again.
2. If the picture does not appear, perform the following sequence of joystick keys:
press ENTER, UP, RIGHT, press ENTER.
Successful completing these steps restores factory settings (AHD 1080p, PAL).
NOTE:
Camera got four available modes: AHD, CVI, TVI and analog 960H. To use each mode user
need to press and hold joystick in selected position for at least 5 seconds.
Power supply connector
CVI
AHD
