NHDC
-
5VE
-
5101, NHDC
-
5H
-
5101
User's manual
version 1.0
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA sp. z o.o.
7
4. Mounting
4.1. Bullet cameras
-
NHDC
-
5H
-
5101
•
Referring to the location of the holes in the foot of the camera or using the mounting template,
mark the points for future mounting holes and the signal cable
•
Drill mounting holes and a hole for the signal cable.
•
Fix the camera foot using the enclosed pegs and screws, and connect the wires.
•
Loosen the lock screws and adjust the position of the camera.
•
After completing the adjustment, screw and tighten the lock screws.
4.2. Vandal proof cameras
-
NHDC
-
5VE
-
5101
•
Loosen the Allen screw locking the base.
•
Remove the camera cover, take the camera out of the base.
•
Referring to the location of the holes in the base of the camera or using the mounting template,
mark the points for future mounting holes and the cable gland.
•
Drill mounting holes and a hole for the signal cable.
•
Secure the base with the included dowels and screws, and connect the wires.
•
Place the camera on the base, put on the cover and pre
-
tighten the base locking screw.
•
Adjust the position of the camera, and then tighten the base locking screw until it stops.
The declared degree of protection applies to camera housing, and does not take into account the
possibility of moisture penetrating through the connectors and connecting cables. Protecting the
connectors and cables against moisture is the responsibility of the installer. The manufacturer is
not liable for damages resulting from failure to fulfill the above
-
mentioned obligation.
5. Electrical connections
The camera should be powered by a stabilized power supply with parameters compatible with the
camera power supply. For the output of the video signal, use a coaxial cable with an impedance of 75
Ω,
terminated with a BNC plug.
INSTALLATION AND ELECTRICAL CONNECTIONS
-
BNC socket, video signal output
-
12VDC power socket
