23
22
Complete the Installation
1. With the Connector attached to the low-voltage wires, position
the Controller’s stake where it will be installed. Loosely guide
the top of the Controller with the palm of your hand. Use your
foot to push down the spike and drive it into the ground.
Note: do NOT pull on the Controller while pushing the spike
down, as this may damage the unit.
2. Once the Controller is in place, the Connector can be settled
above or below ground.
Reconnect the Transformer
2. If necessary, turn OFF any photo-sensors or timers that would
interfere with the Wireless Controller.
3. When the Controller has power, it can be added to your system
on the app and can be set as a zone.
1. Turn the power ON at the circuit breaker or fuse, and / or plug
your transformer in, and turn it ON.
Note:
It’s important the transformer remains ON continuously
and does NOT automatically shut off. ensure your transformer is
set to MANUAL ON or continuous ON.