02/17 Rev. 02
SERVICE MANUAL
Attachment, Setup, Service
Rewinder
2000
3
System requirements
Printer
type
The rewinder can be operated with the following printer types:
•
TTX 350
•
TTK
•
64-xx
•
AP 5.x
•
AP 7.t
•
XLP 50x
Preparation for peripheral devices
For using the printers with a rewinder, they must be especially equipped
(see Tab. 1). This so called peripherals preparation consists mainly of an
additional output stage board for the motor of the peripheral device and of
someadditional connection cables.
Printer
Peripherals Preparation
64-xx
Optional
TTX 350
Optional
TTK
Standard
AP 5.x / XLP 50x Standard with printer version „Peripheral“
AP 7.t
Standard
Tab. 1 Only the TTK is always equipped with the peripheral preparation. For the other
printer types this is an option.
Peripheral test
Do the following, if you are not sure, wether the printer is equipped with
peripheral preparation:
•
TTK / TTX 350:
Set parameter
SYSP > PEPH
to KNIF.
If the printer displays the status message ST68 after the ENTER key is
pressed, the peripheral board is not installed. If ST68 does not appear or if
a different status message is displayed, then the printer has been set up for
peripheral devices.
•
64-xx / AP 5.x / AP 7.t / XLP 50x:
Make a service status printout: Call parameter
PRINT INFO > Service Status
.
(XLP 50x) Make a service status printout: Call parameter
Info > Status Printouts
> Service Status
.
(64-xx / AP 5.x / XLP 50x) Printers are equipped with peripheral preparation
if the topic “Peripheraldriver” can be found below the header
“Peripheraldriver” on the printout.
Printer Peripherals preparatioPrinter Peripherals preparation
