Novexx Solutions XLP 504, Service Manual, Page: 37 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 03 37 Service Mechanics
Ribbon rewinding mandrel
Replacing
Tools
• Torx screwdriver, size 20
• Open-ended spanner, size 8
• Allen key 2.0 mm
Removing
1. Removing the rear hood, see chapter Rear hood

on page 23.
2. Pull the toothed belt off the lower toothed belt pulley
and remove it [24A].
3. Measure and note the screw-in depth of nut and
cap [43].

The values determine the setting of the ribbon
brake.
4. Remove the nut [42A].
5. Turn the threaded rod [44A] at the read hex head
out of the cap [44B] and pull it out of the ribbon
mandrel. Remove the cap.
Continued overleaf.
[42] Braking mechanism for ribbon rewinding mandrel.
[43] Measure the screw-in depth of nut (A) and cap (B).
[44] Removing the threaded rod.
A
B
A
B
A
A
B