Novexx Solutions XLP 504, Service Manual

Page: 129 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 09 129 Parameter Menu
Real 1:1 mode
• The printer can print the whole label surface.
• After dispensing a label, the beginning of the next label is drawn back under the print head.
• The output volume is lower than in
Batch Mode or Normal 1:1 Mode .
Find an illustration of the sequence in the description of the „Real 1:1 Mode“ for the cut function
(see parameter
Cut mode

on page 124).
Dispenseposition

Only if Options > Selection > Periph. device = „Tear-off edge“ or „Dispenser“.
Adjusts the dispense position in („+“) or against („-“) the feed direction. Depending on the set dis-
pense position, the dispensed label sticks to the backing paper with a more or less wide strip [145].
The required width of this strip depends on the further processing.

Dispenseposition 0 mm means the front edge of the label is flush with the dispensing edge.
[145]Dispense position of the dispensed label..
Rewind direction

Only with installed and activated „Rewinder 2000“ (
Options > Selection > Periph. device
= „Rewin-
der“).
• Printing inside : The label face shows inwards , when the label stock is wound up.
• Printing outside : The label face shows outwards , when the label stock is wound up.
Rewinder adjust

Only with installed and activated „Rewinder 2000“ ( Options > Selection > Periph. device = „Rewin-
der“).
The rewinder setup compensates differeces in characteristic or assembly of the light barrier.
A setting instruction for the external rewinder „Rewinder 2000“ can be found in the „User Manual
Rewinder 2000“, topic section „Attachement, Setup“, chapter „Setting up 64-xx / AP 5.4 / AP 7.t“ >
„Adjusting the sensor“.
• loose xxx : Setup of the loose dancer arm (xxx = actual sensor value).
Setting range Default setting Step width Easy Plug
[-30.0...20.0] mm -6.0 mm 0.1 mm #PC1017
Settings Default setting Step width Easy Plug
Printing inside, Printing
outside
Printing outside -- #PC1019
Setting range Default setting Step width Easy Plug
--
Dispensed label
Dispense position
Dispensing edge
Backing paper
Z0040E
.cdr