06/08 Rev. 4.05-01
USER MANUAL
Setting up
TTX
x50/67x
–
Wildcats/Wildcats plus
–
S 45/65/95/105
–
TDI/STDI/XXTREME
11
Print head
Adjusting the print head contact
pressure
Different material widths and/or thicknesses
have an influence on the contact pressure of
the thermal strip on the feed roller.
The contact pressure can be set in 3 steps:
1 Position for thin/narrow material
2
Position
for
medium
material
3 Position for thick/wide material
To set:
The red adjusting screw (4) sits above the
ribbon rewind mandrel in a recess in the front
panel and can be turned by means of a coin.
Default setting:
Position 1 for thin/narrow material
To obtain a medium contact pressure,
turn the arrow to position 2 until it
engages.
To obtain a greater contact pressure,
turn the arrow to position 3 until it
engages.
You should always work with the least
contact pressure at which the print
quality is sufficient. This protects the
print head and the whole device.
Excessive contact pressure can lead to
premature wear of the print head.
4
1
2
3
