Novexx Solutions ALX 92x, Service Manual

Page: 653 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
131
Pause input
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Concerns the output signal PAUSE\ of the USI.
Standard (Default setting) A "low" signal for 20 ms switches the DPM / PEM to the
pause status. The pause status equals the status "on-line stopped" and can
be closed by pressing the feed button.
JP6
A signal different from the standard PAUSE\ can be used. Precondition: an
appropriate firmware change (NISTAN).
Start error stop
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Determines the reaction of the machine on a product start error. A product
start error occurs in the following cases:
•
If a further start signal arrives, before the current label is completely printed.
•
If a reprint is requested, before the first label after powering on is printed.
•
If a start signal arrives and no printjob is loaded.
If a product start error occurs, the machine stops and displays the appropriate
status report. At the same time, the following output signals are activated (set
low):
•
ERROR
•
MACHINE STATUS
On Start errors are worked up (the machine stops!) (default setting)
Off Start errors are being ignored.
Internal inputs
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Defines, if the internal inputs (CN300) on the USI board will be used or not.

To find the location of the inputs, refer to the service manual, topic section
"Circuit/Component Diagrams", chapter "USI board".
On The internal inputs will be enabled.
Off The internal inputs will be disabled.