Novexx Solutions ALX 92x, Service Manual

Page: 630 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
108
The diameter of the measuring wheel is shown on the left. The current prod-
uct speed as calculated by the machine appears on the right. If this speed is
not equal to the actual speed, the setting for the measuring wheel diameter
can be changed to align the actual and measured values for the conveyor
speed.
Example shown on display: The speed of the conveyor belt is calculated at
20.6 m/min for a measuring wheel of diameter 200 mm at the current rate of
rotation.
Forw. feed rat.
64-xx

64-xx dispenser only

Only if DISPENSER PARA > Transport mode = „Dual motors“
Forward feed ratio
Setting the forward feed ratio (in dispensing direction)
xxx% Setting range: 90 - 100%; Step width: 1; Default setting: 100%
Backw feed rat.
64-xx

64-xx dispenser only

Only if DISPENSER PARA > Transport mode = „Dual motors“
Backward feed ratio
Setting the backward feed ratio (contrary to the dispensing direction)
xxx%
Setting range: 90 - 100%; Step width: 1; Default setting: 100%
Dispensing motor feed speed
Feed motor feed speed
--------------------------------------------------------------------- 100%

Setting value% =
Dispensing motor feed speed
Feed motor feed speed
--------------------------------------------------------------------- 100%

Setting value% =