Novexx Solutions ALX 92x, Service Manual

Page: 581 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
59
The parity bit is for checking data transmission. If the check shows an error,
a corresponding message is displayed. The setting must be identical at the
sender and the receiver. Normally transmission is set without a parity bit.
Even Even parity.
A parity bit is added so that there is an even number of 1 Bits.
None
No check bit. Sending and receiving without check bit.
Stop bits
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4
AP 5.6

With mounted and connected I/O board only.
The number of stop bits is 2 and cannot be changed.
Data synch.
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4
AP 5.6

With mounted and connected I/O board only.

See parameter Data synch.  on page 56.
Frame error
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4
AP 5.6

With mounted and connected I/O board only.

See parameter Frame error  on page 56.
Serial Port Mode
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4
AP 5.6

With mounted and connected I/O board only.
Setting of the serial interface type.
RS232
Sets Com2 to RS 232.
Data synchronisation may be done by hardware (RTS/CTS) or by software
(XON/XOFF). Maximum cable length is 15 m.
RS422
Sets Com2 to RS 422.
RS 422 is a 4 wire point to point connection, suitable for only one device.
Receiver and driver of the printer are always enabled. Data synchronization
is only possible by software (XON/XOFF). Maximum cable length is 1 km with
twisted telecommunication cable.
RS485
Sets Com2 to RS 485.