Novexx Solutions ALX 92x, Service Manual

Page: 578 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
56
Printer ID No.
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
Printer identification number
Determines the identification number of the printer. In such a way, the printer
can be addressed by the Easy Plug command #!An (n=printer ID).
The use of ID numbers is in particular reasonable for data transfer by RS422/
485 interface, if several printers are connected by one data line. Each of the
connected printers then only incorporates the data mapped to him by #!An
command.
xx Setting range: 0 to 31; Unit interval: 1
Spooler size
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
The memory capacity of the printer buffer can be set according to the require-
ments of each customer.
xxx Kbyte Unit interval: 16-2048 kBytes; step width: 16 kBytes; default setting:
64 kBytes
Unit interval: 16-256 kBytes; step width: 16 kBytes; default setting: 64 kBytes
Offline mode
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
Interf. disabled
Easy-Plug commands are not accepted, while the machine is in offline mode
(default setting).
Interf. enabled Easy-Plug commands are accepted in offline mode.
Interface delay
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6

Only visible, if INTERFACE PARA >EASYPLUGINTERPR > Offline mode = „Interf.
enabled“
After switching from online to offline mode, the printer interface is deactivat-
ed. This parameter offers a setable delay time before deactivating the inter-
face.
xxxx ms Setting range: 0-1000; Unit interval: 100; Default setting: 0