Novexx Solutions ALX 92x, Service Manual

Page: 202 / 824

06/16 Rev. 09 SERVICE MANUAL Service Mechanics
DPM – PEM – ALX 92x
4
General Notes
Illustrations and Descriptions
DPM or ALX The following descriptions are largely applicable both to DPM and to
ALX 92x. The latter will be referred to as "ALX" below. Some sections apply
to only one of the two types of machine. In such cases the machine type will
be shown after the heading in brackets.
Figures Texts are accompanied by figures where necessary. Figures are indicated
using figure numbers in [square brackets]. A capital after a figure number, for
example [12A], refers to a specific section of the figure.
Serial numbers Some assemblies were subject to one or more constructive changes and can
therefore be ordered in several versions. The spare parts catalog notes in
those cases the serial number or the production month/year of the machine,
which is required to be compatible with the respective assembly.
The serial number can be found on the rating plate of the machine as illustra-
ted below [1].
[1] Rating plate at an ALX 924. The machine was built 04/2013 and has the
sequential number 000001.
Factory Settings
All of the parameters are set to default values by the manufacturer. These
vary from model to model. The factory settings can be restored at any time
using the parameter
SPECIAL FUNCTION > Factory settings
.
Default Values Requirements: The parameter
SPECIAL FUNCTION > Default values
is set to ""Stan-
dard". If it is set to "User setting", the values that were current when "User
setting" was selected are restored.

More details on factory settings can be found in the topic section ’Info-Prin-
touts and Parameters’, parameter
SPECIAL FUNCTION > Factory settings
.
xxxxxxyymm
yy = year, mm = month
xxxxxx = sequential number