Novexx Solutions A8679, User Manual

Page: 9 / 17

03/10 Rev. 5.04-01 USER MANUAL Mounting & Setting
LA-BO
8
Parameter settings on the ALS 20x/256
Firmware 1.10
Firmware 1.33
(Standard signal
interface)
Firmware 1.33
(Applicator
interface)
¯
The
APPLICATOR PARA
menu appears, if the optional applicator interface is
installed.
Menu Parameter Value
MACHINE SETUP Act. Apl. Interf.
„Int. appl. Interf.“: Activates the internal
applicator interface.
„Ext. appl. Interf.“: Appears only if the
optional applicator interface is installed.
LABEL SETUP Lab. stop offset
19.0 mm (also depending on distance of
label sensor to disp. edge, label must be
entirely dispensed)
APPLICATOR PARA Applicator type
ASA
Apply mode
„After start sig.“
(preferred setting for maximum output
capacity)
Blow on time
60 ms
[Tab. 1] The parameter settings required for operating the LA-BO applicator on an
ALS 20x/256 (Labeller firmware version: 1.10).
Menu Parameter Value
LABEL SETUP Lab. stop offset
19.0 mm (also depending on distance of
label sensor to disp. edge, label must be
entirely dispensed)
SIGNAL INTERFACE Interface mode
„Applicator int.“
SIGNAL INTERFACE
> APPLICATOR INT. Applicator type
ASA
Apply mode
„After start sig.“
(preferred setting for maximum output
capacity)
Blow on time
60 ms
[Tab. 2] The parameter settings required for operating the LA-BO applicator on an
ALS 20x/256 (Labeller firmware version: 1.33).
Menu Parameter Value
LABEL SETUP Lab. stop offset
19.0 mm (also depending on distance of
label sensor to disp. edge, label must be
entirely dispensed)
APPLICATOR PARA Applicator type
ASA
Apply mode
„After start sig.“
(preferred setting for maximum output
capacity)
Blow on time
60 ms
[Tab. 3] The parameter settings required for operating the LA-BO applicator on an
ALS 20x/256 (Labeller firmware version: 1.33).