Novell OPEN ENTERPRISE SERVER 2 SP2 - ADMINISTRATION, Implementation Manual, Page: 111 / 288

Network Services 111
n
ov
do
cx (e
n)
22
Ju
n
e 20
09
Existing Tree
When a server joins an existing eDirectory tree, both OES installations do approximately the same
thing.
Š
“OES 2” on page 111
Š “NetWare 6.5 SP8” on page 111
OES 2
If you are installing into an existing tree, the OES 2 install proposes to use the IP address of the
eDirectory server (either NetWare or Linux) as the NTP time source. This default should be
sufficient unless one of the following is true:
Š
The server referenced is a NetWare 5.0 or earlier server, in which case you need to identify and
specify the address of another server in the tree that is running either a later version of NetWare
or OES 2.
Š
You will have more than 30 servers in your tree, in which case you need to configure the server
to fit in to your planned time synchronization hierarchy. For more information, see
“Planning a
Time Synchronization Hierarchy before Installing OES” on page 107 .
The OES 2 install activates the xntp daemon and configures it to synchronize server time with the
specified NTP time source. After the install finishes, you can configure the daemon to work with
additional time sources to ensure fault tolerance. For more information, see
“Changing Time
Synchronization Settings on a SLES 10 Server” on page 112 .
NetWare 6.5 SP8
If you are installing into an existing tree, the NetWare 6.5 SP8 install first checks to see whether you
manually configured either NTP or Timesync time synchronization sources while setting the server
Time Zone (see “
Setting the Server Time Zone and Time Synchronization Method ” in the NW65
SP8: Installation Guide ).
If you will have more than 30 servers in your tree, you should have developed a time
synchronization plan (see
“Planning a Time Synchronization Hierarchy before Installing OES” on
page 107 ) and used the Time Zone panel to configure your server according to the plan.
If you haven’t manually configured time synchronization sources for the server (for example, if your
tree has fewer than 30 servers), the install automatically configures the Timesync NLM to point to
the IP address of the server with a master replica of the tree’s [ROOT] partition.
12.3.5 Configuring and Administering Time Synchronization
As your network changes, you will probably need to adjust the time synchronization settings on
your servers.
Š
“Changing Time Synchronization Settings on a SLES 10 Server” on page 112
Š
“Changing Time Synchronization Settings on a NetWare Server” on page 112