Novell IDENTITY MANAGER 3.6.1 - STAGING BEST PRACTICES GUIDE 2010, Implementation Manual, Page: 15 / 54

Implementation Checklist
2
15
no
vd
ocx
(e
n)
17
Sep
te
m
be
r 20
09
2
Implementation Checklist
Use the following checklist to ensure that you complete all of the tasks required to set up and use the
WorkOrder driver.
Table 2-1
WorkOrder Implementation Checklist
Task Details
‰
Install the WorkOrder
driver files By default, the WorkOrder driver files (driver shim and configuration file)
are copied to the Metadirectory server when the Metadirectory engine is
installed. If the driver is not on the Metadirectory server (because a custom
installation was performed, or you want to run the driver on a server other
than the Metadirectory server), see
Chapter 3, “Installing Driver Files,” on
page 17 .
‰
Create a new
WorkOrder driver
or
Upgrade an existing
WorkOrder driver to
the new version
You need to import the basic configuration file to create the driver. For
instructions, see
Chapter 4, “Creating a New Driver,” on page 19 .
If you have an existing driver, you can upgrade its configuration to this
version. For instructions, see
Chapter 5, “Upgrading an Existing Driver,” on
page 27 .
‰
Customize the driver The basic configuration for the WorkOrder driver enables it to create
WorkOrder objects and WorkToDo objects. This is the extent of what the
WorkOrder driver does when using the base configuration. For any
additional work to be done, you must customize the WorkOrder driver or
other Identity Manager drivers to perform the desired work.
For instructions, see Chapter 6, “Customizing the Driver,” on page 29 .
‰
Create work orders Most work orders are likely created by other drivers as part of the work
order process you establish while customizing the driver (see the previous
task). However, you can also create work orders manually as well as
modify existing work orders.
For instructions, see Chapter 7, “Creating and Managing Work Orders,” on
page 35 .