Novell ACCESS MANAGER 3.1 SP1 - ADMINISTRATION, Installation Manual, Page: 15 / 42

Additional Information on Installing And Configuring
3
15
no
vd
ocx
(e
n)
17
Sep
te
m
be
r 20
09
3
Additional Information on
Installing And Configuring
This section describes in detail the procedure to install and configure the Linux Access Gateway on
RHEL. Use these section as a reference to install and configure Linux Access Gateway on RHEL.:
Š
Section 3.1, “Before You Begin,” on page 15
Š
Section 3.2, “Installation and Disk Layout,” on page 15
Š
Section 3.3, “Installing the Linux Access Gateway,” on page 16
Š
Section 3.4, “Configuring Hardware and System Services,” on page 27
Š
Section 3.5, “Verifying the Linux Access Gateway Installation on RHEL,” on page 34
Š
Section 3.6, “Configuring the Linux Access Gateway to Boot from RHEL,” on page 35
Š
Section 3.7, “Starting the Linux Access Gateway from RHEL,” on page 36
Š
Section 3.8, “Configuring the Linux Access Gateway after It Is Installed on RHEL,” on
page 37
3.1 Before You Begin
1
Before you begin the installation, make sure that the minimum system requirements are met.
For more information, see
Section 1.1, “System Requirements,” on page 9 .
2 Execute the following commands to note the hard disk partition entries on the RHEL server:
mount
fdisk -l
df -h
3 (Conditional) If you are installing the Linux Access Gateway on an existing partition, comment
out the entries in
/etc/fstab
for the
/lag
partition selected for the installation.
For example, the
df -h
command displays the following output, which shows
/lag
as the
existing partition where you would install the Linux Access Gateway:
Filesystem Size Used Avail Use% Mounted on
/dev/sda1 10G 1.9G 8.1G 20% /
/dev/sda3 100G 173M 99.8G 1% /lag
tmpfs 506M 0 506M 0% /dev/shmf -h
3.2 Installation and Disk Layout
The hard disk layout before and after the Linux Access Gateway is installed on RHEL 5.1 is shown
in
Figure 3-1 on page 16 :