CPT7 and CPT7700 Installation and Operation User Manual v12
42
Chapter 3 OEM7 Receiver Operation
Before operating the receiver for the first time, use the installation instructions in
The following instructions are based on a configuration similar to the following figure.
Figure 12: Basic CPT7 Connection Interfaces (example)
The figure above does not show all necessary hardware. Also see
Figure 13: Basic Differential Setup
on page 47 for a base/rover example.
3.1 Communications with the Receiver
Communication is established with the receiver using a data terminal or computer connected to the receiver
by a variety of methods:
l
l
l
l
l
When connected to the receiver, enter commands directly from a terminal or through terminal emulation
software on a computer. For example:
