NOVATECH ApS - Skudehavnsvej 30 - DK 9000 Aalborg. P.O.Box 540
Tel. +45 98 16 50 09 Fax +45 98 16 80 97 [email protected]
24
7.
Maintenance
7.1.
Maintenance manual
The Roll Trailer must frequently be checked as follows:
Chassis:
Eventually cracks on welds or beams must be properly repaired.
Landing Gear:
Minor dents can be accepted, major must be repaired before use
Front and rear beam:
Only dents below 25mm on the upper flange downwards can be accepted. Upwards dents
are not accepted.
Side Beams:
Bending downwards and sideways can be accepted. Dents below 25mm can be accepted.
Cross Members:
Dents below 25mm sideways in flange can be accepted. Dents below 10mm downwards
can be accepted.
Forklift Pockets:
Only minor dents below 15mm can be accepted
Deck:
Steel Deck - broken deck should be repaired or replaced. Dents downwards over the wheel
are acceptable.
Rocker Arm and Axles:
Any cracks on the axles should be repaired. Axle’s pins and bushings should be replaced
according to maintenance schedule. To be frequently checked for proper function. In case
of malfunction, supplier is to be contacted for decision. Axle’s bolts must be frequently
WARNING
High danger level
Possible danger of death or severe injury
All maintenance in only permitted to be done on an empty trailer;
If during operation occurs any failure – empty the trailer immediately;
