Wiring the RTS-UVC
The RTS-UVC is a two-wire device. Use the following procedure and refer to
Figure 2, as necessary, to wire the sensor.
Step
Procedure
1
Connect the sensor’s red wire to Terminal 5 on the module.
2
Connect the sensor’s black wire to Terminal 4 on the module.
Model and Part Number
Use the part number shown in Table 1 to order the necessary Novar Controls part.
Table 1. Novar Controls Part Numbers
PRODUCT
MODEL NO.
PART NO.
Supply-Air Temperature Sensor
RTS-UVC
736003000
THE CONTENTS OF THIS DOCUMENT ARE SUBJECT TO CHANGE WITHOUT NOTICE.
COPYRIGHT © 2004 BY NOVAR CONTROLS CORPORATION. ALL RIGHTS RESERVED.
PRINTED IN THE U.S.A.
NOVAR CONTROLS CORPORATION
6060 ROCKSIDE WOODS BLVD., CLEVELAND, OH 44131
TEL.: 800.348.1235
WWW.NOVARCONTROLS.COM
2
DOC. #560051000—A
7/30/04
Supply-Air Temperature Sensor (RTS-UVC) Installation Instructions
Black
UVC TERMINAL STRIP
UVC/ETC SUPPLY AIR
TEMPERATURE WIRE
Red
2
12
1
11
+5V
E
ADJ
D
3
13
S1
F
4
14
COM
GND
TEMP
SENSOR
INPUT
AUX
POT
ANALOG
OUTPUTS
0-10VDC, 1mA MAX
STATUS
INPUT
OVER-
RIDE
SWITCH
5
S2
6
DI 1
7
RET
RET
8
DI 2
9
O/R
10
Figure 2.
RTS-UVC wiring connections