21
Mounting and Connection Instructions -
026421
Novar R/W reader with keypad
F
I
a)
b)
c)
Adjustment mode
Maximum range
Transponder identification
LED indicator during the setting process:
maximum possible
range
yellow LED
top green LED
The flashing rhythm of the green LED indicates
whether transmission is safe at many (a), a few (b)
or only at one (c) of the 16 possible power stages.
This is an indication of how much power is still
available up to the maximum possible distance.
If the transponder reaches the
, the green LED only flashes once (c). The
flashes additionally and signalizes that
a greater distance cannot be exceeded.
During adjustment, hold the transponder steadily in the reading range. We recommend
using a non-metallic object as a "spacer" between the reader and the transponder.
Set:
reader
-
As soon as the transponder is identified,
begins to flash.
Adjustment begins LED indicator see above)
-
After approx. 5 sec. adjustment is completed.
Important:
acoustic signal
-
Hold a transponder at the desired distance to the
.
-
(
Acknowledgement:
- Brief
-
adjustment indicator goes off.
The
-
The transponder can be removed.
As long as the transponder is still in the reading field after adjustment is completed, the data stored
is indicated by the top green LED flashing. This no longer influences adjustment. The stored input
is used in normal operation.
reader
"
"
Adjustment can be repeated as often as desired and at all times. The setting mode must be
activated and the setting mode indicator must flash. Hold the transponder in the reading field of the
reader to reset.
:
Press key "3" to deactivate the adjustment mode.
Repeat adjustment
Deactivate adjustment mode
If the transponder is moved out of the power field of the
, the adjustment mode indicator
flashes again after a dead time of approx. 3 sec., and it can be reset if necessary.
ID card
or other
transponder
22
7.5
7.6
Transponder detection
7.7
Exit programming mode
Press key "X"
.to exit programming mode.
Keypad lighting
In its state at the time of delivery, the illuminated no-load status (no operating procedure) is
switched off. It is activated and lit up fully only for 5 seconds if a button is pressed or a transponder
is held in the reading range.
If you require permanent illumination, the brightness for the no-load status can be set in steps
using button "4" and "5". This does not affect the full brightness during operation.
Every time the button is activated, the illumination becomes gradually darker until it is
fully switched off.
The brightness increases in steps until it reaches maximum brightness.
The set value is permanently saved when the programming mode is exited.
In its state at the time of delivery, the antenna is actuated in cycles (60 ms active, 300 ms pause) to
achieve medium current consumption. In certain cases this may result in the transponder not being
fully identified the first time it is held in the reading range.
The antenna is permanently activated using button "8".
re-establishes the state at the time of delivery (cyclical actuation).
Button "4":
Button "5":
Button "8":
Button "7":
8.
Accessories
023315
023316
023501
023329
White front (similar to RAL 9010)
PU = 3 pce.
Anthracite front (similar to RAL 7024)
PU = 3 pce.
Plastic shield weather/view
Mounting plate
PU = 3 pce.
ID carrier
Apart from Legic and mifare, all contactless Novar information carriers can be used as ID carriers.
Please refer to the current product group catalogue (AC, TR and IDT).
Mounting and Connection Instructions -
026421
Novar R/W reader with keypad
