INPUT/OUTPUT SIGNALS
PAGE
|
57
Input/output signals
V40’s input/output signals are divided into three categories: auxiliary DC power, input signals, and
output signals. Signals in each category are fully described in the section below. Figure below illustrates
the pin arrangement of the User I/O (15-pin female D-type subminiature) connector on v40 ’s rear panel.
Important Note: See DB-9 connections later in this section for signal descriptions and pinouts of
the SAB model’s side-mounted DB-9 connector.
Figure 4-5 User I/O connector pinouts
Caution: Possible Equipment Damage
Turn off DC power before installing or removing any plug or cable from the User I/O connector.
Ensure that user connections are made to the appropriate pins and that the appropriate signal levels
are applied. Failure to do so may damage the laser.
Summary of Contents for v40
