Novanta Precession Elephant 2, User Manual

Page: 34 / 103

PRECESSION ELEPHANT 2 Scan Head 2 Instruction Manual 2021-09-22
Parameter Value
Duty cycle 0
5. Proceed with subsection 6.5.3 on page 34 .
6.5.3 Optional afemlight device
The AFEM hardware is optional and may not be present in your scan head.
Procedure
1. If your scan head does not have the AFEM hardware then skip this procedure
and proceed with the next one.
2. In the InScript software in the
Navigator
view,
in the controller’s
Devices
subtree,
select the afemlight device.
3. If the device is not present then create, configure and activate it as described in
document [ InScript ] chapter
Managing Devices
and in document [ Firmware ]
chapter
Devices  Sensor  AfemLight
.
4. In the
Node Properties
view, check, if the following variables are set to the
values listed below and correct them if necessary.
Parameter Value
– –
5. Proceed with subsection 6.5.4 on page 34 .
6.5.4 Optional shutter device
The shutter hardware is optional and may not be present in your scan head.
Procedure
1. If your scan head does not have the shutter hardware then skip this procedure
and proceed with the next one.
2. In the InScript software in the
Navigator
view,
in the controller’s
Devices
subtree,
select the
shutter
device.
34