10
NOTICE:
The foot pedal may arrive with the top separated from the bottom. This is not damage. To install the
top, flip the pedal spring under the cover to the forward position (towards transmitter end). Align the
spring loaded pivot pins with the corresponding holes in the pedal top. The pins are spring loaded
and can be squeezed so that the top slides down onto the pins. The pins will pop out into the holes
and allow the top to pivot once the pins and holes are properly aligned. If resistance is felt or the pe-
dal does not want to go together, you may need to make sure the pressure return spring is flipped so
that it pushes back against the pedal as it is assembled. There will be moderate resistance as the pe-
dal goes together, but it should be a firm, evenly felt resistance. Similarly, the foot pedal may be dis-
assembled for adjustment by simply by pressing in on the ends of the pins with a dull awl, or Phillips
type screw driver on both sides to remove the top. Once both pins have been pressed in, the pedal
top should pop up for access to the foot pedal switch travel adjustment and other parts.
Setup Guide
Push in on left and right side pivot pins to remove or
seat cover. Pins should pop through corresponding
holes in the cover when seated properly.