LED SPOT 150W Product Datasheet
LED SPOT 150W Product Datasheet
04
07
MENU
Description
8.
MENU OPERATIONS
4.PHOTOMETRICS DIAGRAM
Distance
2.5m
5m
7.5m
10m
15m
13
°
150W(LUX)
Diameter(m)
25200
5520
3276
1716
1152
ø
0.41
ø
0.82
ø
1.23
ø
1.65
ø
2.64
5.OPERATION INSTRUCTIONS
●
The LED SPOT 150W is for beam effect for on-site decoration purpose.
●
Don’t turn on the fixture if it’s been through severe temperature difference like after transportation
because it might damage the light due to the environment changes. So make sure to operate the fixture
until it is in normal temperature.
●
This light should be kept away from strong shaking during any transportation or movement.
●
Don’t pull up the light by only the head, or it might cause damages to the mechanical parts.
●
Don’t expose the fixture in overheat, moisture or environment with too much dust when installing it. And
●
don’t lay any power cables on the floor. Or it might cause electronic shock to the people.
●
Make sure the installation place is in good safety condition before installing the fixture.
●
Make sure to put the safety chain and check whether the screws are screwed properly when installing
the fixture.
●
Make sure the lens is in good condition.
It’s recommended to replace the units if there are any damages
or severe scratch.
●
Make sure the fixture is operated by qualified personnel who knows the fixture before using.
●
Keep the original packages if any second shipment is needed.
●
Don’t try to change the fixtures without any instruction by the manufacturer or the appointed repairing
agencies.
●
It is not in warranty range if there are any malfunctions from not following the user manual to operate or
any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
MENU
UP
DOWN
ENTER
LCD DISPLAY
DMX
(Function Mode)
Dmx Address
A001~AXXX
DMX address setting
Channel Mode
CH14 MODE
Standard mode
CH12 MODE
Vector mode
Auto Run
Program1~9
Master/Alone
Auto run
Music Run
Program1~9
Master/Alone
Sound Control
SET
(Fixture Set)
Reset Default
Yes/No
Reset Default
Signal Set
Wire
Wire DMX
Reverse Pan
(On/Off)
Reverse Pan
Reverse Tilt
(On/Off)
Reverse Tilt
Select Pan
630°/540°/360°
Pan Degree, default is 540°
Select Tilt
270°/180°/90°
Tilt Degree, default is 270°
Mic Sensitivity
0~99%
MIC Sensitivity Setting
OFF Signal Mode
(On/Off)
OFF at original status and
ON at reset status when no
DMX signal
Half Color Wheel
(On/Off)
Half color Select
Manu
(Manual)
Reset
Total Reset
Total Reset
Scan Reset
Scan Reset
Color Reset
Color Reset
Gobo Reset
Gobo Reset
Others Reset
The Others Reset
Channel
PAN=XXX……
Channel Control
ADV
(Advanced)
(Access Code 088)
Calibration
PAN=XXX……
Calibration