NFS-320/E/C Installation Manual —
P/N 52745:M2 7/1/14
19
Installation Checklist
Installation
3.2 Installation Checklist
Table 3.1 provides an installation checklist for installing, wiring, and testing the NFS-320/E/C
system. It has references to installation information included in manuals listed in Section 1.3
“Related Documents”.
Seq
Task
Refer to
1.
Mount the cabinet backbox to the wall.
Section 3.3 “Mounting a Cabinet”
2.
If adding option boards such as such as wire and/or fiber
version of the NCM/HS-NCM or TM-4:
• Remove keypad.
• Install option boards
• Replace keypad
Section 3.4 “Installing Option Boards”,
Section 1. “Remove and re-install KDM-R2 as shown in
Figure 3.2. It may be convenient to do some basic field-
wiring before reinstalling KDM-R2.”, and Section 3.4
“Installing Option Boards”
Also see option board documentation for board-specific
details.
3.
Optional: Install auxiliary power supply and/or external
battery charger; set backup-alarm switches.
Auxiliary power manuals, Section 3.8 “Backup-Alarm
Switches”
4.
Connect AC wiring, place batteries into backbox without
connecting them, and run cable to optional power supplies,
DC power outputs, NACs, and relays.
CAUTION: Do not apply AC or DC power at this time.
Section 3.5 “Connecting the Power Cables”
5.
Optional: Install output devices such as a printer, or CRT
terminal.
Section 3.11 “Installing Remote Printers and/or CRT”
6.
Wire annunciators and network connections.
Relevant product manuals
7.
Wire the Signaling Line Circuits.
Section 3.12 “Wiring a Signaling Line Circuit (SLC)”
8.
Terminate wire shielding as instructed.
SLC Wiring Manual
9.
Apply AC power to the control panel by placing the external circuit breaker to the ON position.
Do NOT connect batteries
.
10.
Check AC power.
Table 3.2 in Section 3.5 “Connecting the Power Cables”
11.
Connect the batteries using interconnect cable, P/N 75560 and 75561.
12.
Program the control panel.
NFS-320/E/C Programming Manual and VeriFire Tools
Online Help.
13.
Field test the system.
Section 5 “Testing the System”
Table 3.1 Installation Checklist
Location for 1 or 2
option boards
Figure 3.1 NFS-320/E/C in Cabinet
Top two
mounting holes
Two lower
mounting holes
are behind
batteries.
