LEG PAD BUCKLE ADJUSTMENT:
• Open the Leg strap connect buckle by pressing in the center
of the buckle and release the single slot frame from main
buckle
• Adjust the length of the webbing by pulling on webbing in
either direction to move the main buckle frame
• Close buckle and test fit, continue adjustment until leg pads
are snug
•Repeat for opposite side of leg strap
•Fold the excess strap into the elastic leg strap loop keeper
• Proper adjustment of the leg pad straps will ensure the leg
pads will be in the most comfortable position on your legs
REAR LEG STRAP ADJUSTMENT:
• Adjust the length of the elastic webbing by pulling in either
direction through the plastic friction buckle, retain excess
webbing in the strap loop keeper
• Proper adjustment of the rear leg strap will ensure the pads
are in the correct distance below the waist
USING BRIDGE ANCHOR PLATES:
Bridge anchor plates are designed for maximum strength along
their major axis. Anchor plates should be loaded ONLY between
the single slot shaped connector holes and any combination of
the other three round holes. Only use the bridge anchor plates
for tie-in the rope bridge and only use both plates together.
Inspection:
Prior to each use, carefully inspect this equipment for
indications of wear or deterioration. The inspection should
include but not be limited to inspection for:
•tearing, cuts, severe abrasion of the webbing or rope
•burnt, singed, or melted webbing or rope
• faded, discolored from exposure to ultraviolet light, chemical
exposure of webbing or rope
•torn or pulled threads (broken fibers)
• nicks, cracks, distortion or corrosion of hardware (buckle,
rigging plate, D-ring, etc.)
•nonfunctional buckles
•evidence of involvement in dynamic fall
•readability of the marking
•if there are any indications for impact loading
Note: All load bearing bartacks are constructed of contrast
color stitching for easy identification. Replace suspension
bridge if protective cover of stitching (shrink tube) is damaged,
missing or torn.
If any evidence of wear or deterioration as outlined is observed,
immediately cease use, destroy the product and replace with
new equipment. Should any unusual condition conditions not
outlined above be observed, or you have reasonable doubt
about a particular condition, remove the equipment from
service. Failure to carefully and completely inspect your
equipment could result in serious injury or death. Notch
Equipment recommends a detailed inspection by competent
person at least once every 12 months (depending on current
regulations in your country, and your conditions of use). Record
the results on your PPE inspection form: type, model,
manufacturer contact info, serial number or individual number,
dates: manufacture, purchase, first use, next periodic
inspection, problems, comments, Inspector’s name and
signature.
Summary of Contents for Sentinel Arborist Harness
Page 1: ......
