Norwood Kwik-Till HSD2500, Operator'S Manual

Page: 86 / 154

4 - WORKING OPERATIONS
4-20
Adjusting The Hitch Link
1. Use a 1-1/2” wrench & 1-7/16” socket to remove the (Qty.
3) 1”-8 x 8-1/2 Hex Head Bolts
B
, & (Qty. 3) 1”-8 Nylock
nuts
C
.
(See Fig. # 4-54)
NOTE
Cat. IV Hitch links use (Qty. 2) Hex Head Bolts & Nuts,
and Cat. V Hitch links use (Qty. 3) Hex Head Bolts & Nuts.
2. Determine the new location of the clevis. (Example, Po -
sition # 1, Position # 2, Position # 3, or Position # 4. (See
Fig. # 4-52) (See Fig. # 4-53)
3. If the hitch end of the Kwik-Till is too high, then move the
hitch link to a higher position. (See Fig. # 4-50)
4. If the hitch end of the planter is too low, then move the
hitch clevis to a lower position. (See Fig. # 4-51)
5. Once the hitch is level, tighten the hardware securing the
hitch clevis to the hitch tongue.
D
C
A
B
Fig. # 4-54 Adjusting The Hitch Link