Norwood Kwik-Till HSD2500, Operator'S Manual

Page: 114 / 154

5 - MAINTENANCE
5-22
MONTHLY
Check Disk Shank Cord Alignment
1. Fold the machine into the Transport Position .
(See
“Kwik-Till Folding & Unfolding” on page 4-11)
WARNING
When servicing the machine in the transport position, the
wings must be secured with the transport locks.
2. Make sure the Transport Locks
A
are moved from
the Stowed Position
C
, and installed into the Locked
Position
B
.
(See Fig. # 5-18)
Fig. # 5-18 Transports Lock Shown In Locked Position
A
B
D
C A
3. Check Disk Shank Cord
E
alignment. (Qty. 4 Per Disk
Shank)
(See Fig. # 5-19)
4. The Cords
E
should not extend more than 3/4” from the
Tube Caps
F
.
(See Fig. # 5-19)
E
F
Fig. # 5-19 Check Disk Shank Cord Alignment
5. If Cords
E
extend greater then 3/4” from the Tube Caps
F
, the Cords
E
should be readjusted.
E
F
3/4 in
(1.58 mm)
Fig. # 5-20 Check Disk Shank Cord Alignment
Adjusting Disk Shank Cords
1. Loosen (Qty. 4) 5/8” Nylock Nuts
G
. Only loosen the
Nylock Nuts enough to allow movement of Disk Shank
Cords
E
. Do not completely loosen the
Nylock Nuts
.
(See Fig. # 5-21)
Fig. # 5-21 Loosen (Qty. 4) 5/8” Nylock Nuts
G
G
E