22
Figure: C13PE Belt Tensioning Assembly
6. To apply tension to the Belts tighten (turn clockwise) the rear 3/8” Jam
Nut until the required Belt Tension is achieved. To loosen the Belts turn
the front 3/8” Jam Nut counter clockwise until the required Belt Tension is
achieved. (See
Figure: C13PE Belt Tensioning Jam Nut Directions
).
NOTE: Do not over tighten the belts as too tight of belts can break
Engine Output Shafts, Blade Shafts, Belts, and cause premature Bearing
Failures. Failures due to too tight of Belts are not covered by any
warranty. Too loose of Belts will cause the Belts to slip under load, and
may cause burning of the Belts and is not covered under any warranty.
3/8” Jam Nut
3/8” Jam Nut
