Norton Clipper CM 42, Operating Instructions Manual

Page: 13 / 25

VERS. 2015.07.06 CM 42_MAN_EN
13
3.4 Starting the machine
Open the cover on the switch and press the green button to start the machine. Either press on the
red button or directly on the switch cover to stop the machine.
3.5 Water cooling system

Fill the water pan with clean water to approximately 2cm from top (ensure that bottom of pump is
fully immersed in water). Use the pump switch on the side of the main switch to start the pump.

Open the water-tap on blade guard (note that handle on water-tap should be in line with water-
flow).

Ensure that water is flowing freely in the circuit and is delivered adequately to both sides of the
blade, as insufficient water supply may result in premature failure of the diamond blade.

The water pump must never run without water. Always make sure that there is enough water in
the pan and refill if necessary.

In case of frost, empty the water cooling system from its water.