Norton Clipper 70184628167, Operating Instructions Manual

Page: 11 / 24

11
3
Assembly and commissioning
The machine is delivered fully equipped (although without diamond blade). It is ready for operation
when you mount the diamond blade, the handles and the conveyor cart and after you connect to the
appropriate power supply.
3.1 Tool assembly
Only NORTON blades with a maximum diameter of 400 mm can be used with the CM 41.
All tools used must be selected with regard to their maximum permitted cutting speed for the
machine’s maximum permitted rotation speed. Before mounting a new blade into the machine,
switch off the machine and isolate it from the main source of electricity.
To mount a new blade, follow these steps:

Loosen the clamp on the front of the blade guard, disconnect the water hose on the left side of it
and open the blade guard.

Loosen the hexagonal nut on the blade shaft ( attention: left threaded), which holds the
removable outer flange.

Remove the outer flange.

Clean the flanges and blade shaft and inspect for wear.

Mount the blade on arbour ensuring that direction of rotation is correct. Wrong direction of
rotation blunts the blade quickly.

Replace outer blade flange.

Tighten hexagonal nut with spanner supplied for this purpose.

Close the blade guard, retighten clamp on the front of the guard and reconnect the water hose.
ATTENTION: The blade bore must correspond exactly to the diameter of the blade shaft. Cracked
or damaged bore is dangerous for the operator and for the machine.
3.2 Conveyor cart and handle assembly
Handle and conveyor cart are located in the water pan.
Place the conveyor cart on the guiding rails with the material stop facing the operator.
Assemble the handles with the supplied M10 nuts and bolts.
3.3 Electrical connections
Check that,

The voltage/phase supply corresponds to the information indicated on the motor plate.

Available power supply must have ground connection in conformity with safety regulations.

The connecting cables should have at least a 2. 5mm
2
-section per phase.
3.4 Starting the machine
Open the cover on the switch and press the green button to start the machine. Either press on the
red button or directly on the switch cover to stop the machine.