16
If you have installed the rails of the rudder
system, check, if they are still in place and
correct if necessary.
Now install cross rib #3.
IMPORTANT
: Make sure, that the ridge
bar can snap into the metal fitting on the
top of the cross rib.
This metal fitting also faces away from the
cockpit.
Again clip in the stringer. Proceed as
before.
Then clip in the ridge bar to the top of the
cross rib.
Now take the half cross rib #4.
That one supports the seat and ensures
that the weight of the paddler does not
press on the stringer element.
It is therefore
essential to install
!
First place he half cross rib diagonally and
then push it into position! Otherwise is not
possible to install.
Clip one end onto the stringer right in
front of the seat. Place the other end
diagonally on the lower stringer and a
bit further to the front.
Then slide the half cross rib into position.
The half cross rib then sits directly in front
of the seat.
1.
2.
