8.
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contain chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals
are lead (from lead based paint), crystalline silica (from bricks, cement and other
masonry products), and arsenic and chromium (from chemically treated lumber).
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals, work in a well-ventilated area
and work with approved safety equipment such as those dust masks that are
specially designed to filter out microscopic particles.
Operation Instructions
Before Use
1.
Make sure that the voltage and frequency indicated on the bottom plate are the same as
your local supply. And the external earthing wire is reliable connected.
2.
Remove the head from the machine, wash the parts dismounted in warm soapy water,
then reassemble them.
3.
Before mincing, first turn lock-handle counter-clockwise, tighten the front nut but not
too tight, or it will damage the motor and the blade.
4.
Before plugging in, ensure Switch is off
Mincing Meat
Step 1: Remove skin and bone from the meat to be minced, cut them into smaller
pieces so that they fit easily into Hopper opening.
Step 2: Feed the pieces into mincing chamber with the feed-stick supplied.
Step 3: Plug in, then switch on.
Step 4: Use food pusher to feed foods into Hopper Plate.
After Use:
Step 1: Make sure that the motor has stopped completely, then switch off and unplug.
Step 2: Dissemble the head, and wash it with clean water immediately after each use,
as to avoid bacteria growth.
Cleaning & Maintenance
1.
Remove meat, etc,
2.
Wash each part in warm soapy water.
Notice: * Do not immerse Motor Housing in water, but only wipe it with a damp cloth.
* Thinners and benzines will crack or change the color of the unit. A little salad
oil on Feed screw and Cutting Plate after washing and drying will keep them
lubricated.
Page: 2 of 4
