![Northern Tool Electric fireplace heater Assembly And Operation Manual Download Page 2](http://html1.mh-extra.com/html/northern-tool/electric-fireplace-heater/electric-fireplace-heater_assembly-and-operation-manual_1708652002.webp)
2
6.
Under no circumstance should this electric fireplace be modified. Parts having to be removed for servicing must
be replaced by a certified repair center prior to operating this electric fireplace again.
7.
Do not use outdoors or anywhere that it can get wet.
8.
This fireplace is not intended for use in bathrooms, laundry areas and similar indoor locations. Never use this
appliance near a bathtub or in the vicinity of water.
9.
Do not place or operate the fireplace insert directly on carpet or a similar surface, which may restrict air
circulation beneath the unit. The fireplace insert must be installed in the mantle before use.
10.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from
traffic area and where it will not be tripped over.
11.
To disconnect fireplace, turn all controls to off, then remove plug from outlet.
12.
When this appliance is installed, it must be electrically grounded in accordance with local codes with the current
CSA C22.1 Canadian local codes for USA installation. Follow local codes and National Electricl Code,
ANSI/NFPA NO. 70 and Canadian Code, CZ 22.2 No. 0.
13.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric
shock or fire, or damage the heater.
14.
To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on soft surfaces, like a bed,
where openings may become blocked.
15.
CAUTION: This appliance gets hot and it contains internal parts that could arc or spark. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored or where the unit will be exposed to flammable
vapors. This fireplace should not be used as a drying rack for clothing. Do not hang Christmas stocking or
decoration on the fireplace heater or mantle. Do not use near propane tanks.
16.
Do not modify this fireplace. Use it only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons.
17.
Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if
you have to use an extension cord, the cord shall be No.16 AWG minimum size and rated not less than 1875 watts,
and 3-wire cord with grounding type plug and cord connector.
18.
Do not burn wood or other materials in this fireplace.
19.
Do not strike fireplace glass.
20.
Always use a certified electrician should new circuits or outlets be required.
21.
Always use properly grounded, fused and polarized outlets.
22.
Always use ground fault protection where required by electrical code.
23.
Always disconnect power before performing any cleaning, maintenance or relocation of the fireplace.
24.
When transporting or storing the fireplace and cord, keep in a dry place, free from excessive vibration and store so
as to avoid damage.
NOTE
: Procedures and techniques that are considered important enough to emphasize.
CAUTION
: Procedures and techniques, which, if not carefully followed, will result in damage to the equipment or
personal property or may cause personal injury.
WARNING
: Procedures and techniques, which, if not carefully followed, will expose the user to the risk of serious
injury, illness or death.