Page 12 of 19
•
Remove the cap and/or lid from both ends of the cartridge (not included). Insert the cartridge into
the tube container in the orientation indicated on the cartridge. Make sure that the cartridge is as
far in as possible. See Figures 10 and 11.
Figure 10 Figure 11
•
Reconnect the tube container to the gun body. Press the locking plate to release the handle.
Press the handle in as far as it will go. See Figures 12 and 13.
Figure 12 Figure 13
•
Make sure that the end of the grease cartridge that is inserted into the tube container is not
damaged or squeezed and is still round. If not, the plunger will be prevented from entering the
grease cartridge, which will prevent the grease from coming out of the tube.
Note: Do not re-use empty grease cartridges.
Bulk Loading
Refer to Figure 14.
•
Remove the tube container (#19) from the gun body.
•
Submerge the open end of the tube container approximately 2 inches into the grease container
(not included).
•
Pull back slowly and extend the tube handle (#22) fully to draw grease upward into the tube
container. Lock the handle into place with the locking plate (#23) when it is fully extended.
•
Reassemble the tube container to the gun body. Press the locking plate to release the handle.
Press the handle in as far as it will go.
Figure 14
