Page: 5 of 8
·
Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended air
pressure of 90 PSI.
·
Check the air connection for leaks.
·
Turn off the compressor and disconnect the air source hose in preparation to load bits into
the Air Needle Scaler.
·
Take out the needle scaler from the box (See Fig. 2), screw it into the cylinder (See Fig. 3),
tighten it (See Fig. 4) and start the trigger.
Fig. 2 Fig. 3 Fig. 4
·
Gently squeeze the trigger and move slowly along the workpiece. Do not push down on the
scaler; let it do the work. If it does not do the intended job to satisfaction, examine your scaler
to see if it is worn or dull.
·
When you are finished, turn off the air supply and then hold the Air Needle Scaler a safe
distance away from yourself and others and squeeze the trigger to bleed off the remaining air.
Then, disconnect the air hose.
MAINTENANCE
WARNING:
Make sure this tool is disconnected from its power source before attempting
any maintenance, cleaning, or inspection.
·
Maintain your tools.
It is recommended that the general condition of any tool be examined
before it is used. Keep your tools in good repair by adopting a program of conscientious repair
and maintenance in accordance with the recommended procedures found in this manual. If any
abnormal vibrations or noise occurs, turn the tool off immediately and have the problem
corrected before further use. Have necessary repairs made by qualified service personnel.
·
Cleaning.
Use only soap and a damp cloth to clean your tools. Many household cleaners are
harmful to plastics and other insulation. Never let liquid get inside a tool.
