Page of 8
5
Figure 1
2.
The Blade (13) is adjusted in the front by twisting the Thread Rod (5) either clockwise into the
Support Frame (4) which will lower the front section, or counterclockwise which will raise the
front section (See
Figure 1
).
Figure 2
3.
The rear section of the Blade is adjusted as follows: Hold the handle of the Blade Guard (9)
firmly while you remove the Adjusting Pin (8). Then, raise or lower the Blade Guard (9) using
one of the four adjusting holes and re-insert the Adjusting Pin (8) at the height you need
(See
Figure 2).
NOTE:
To remove the Adjusting Pin (8) you will first need to remove the Hair Pin Cotter (10). Be
sure to replace the Hair Pin Cotter (10) after adjusting the height of the Blade Guard (9) (See
Figure 2
).
Figure 3
4. Next adjust on Depth Gauge (16) by loosening the Adjusting Knob (15) at the rear of the Base