Page of 8
5
Cleaning.
Use only soap and a damp cloth to clean your tools. Many household cleaners are
harmful to plastics and other insulation. Never let liquid get inside a tool.
Use only accessories that are recommended
by the manufacturer for your model.
Accessories
that may be suitable for one tool may create a risk of injury when used on another tool.
Keep guards in place
and in working order.
Never leave tool running unattended.
Keep drum rotating
when filling or emptying the mixer
CAUTION:
When transporting the mixer, disconnect the power cord. Make sure the drum is
empty of all material.
ASSEMBLY
(Reference Parts List)
1. Insert the Gearbox Motor Assembly Mounting Frame (#19) into the Front Frame (#9) with
Support Leg (#12) so that bolt holes line up. See Fig.1 and Parts Diagram. Insert through
holes of the Gearbox Motor Assembly Mounting Frame (#19) and the front side of the Support
Leg (#12) with Bolt M10 x 70 (#18). And then with Flat Washer 10 (#26), Spring Washer 10
(#27) and Nut M10 (#13). Tighten them by hand. Repeat on other side.
2. Insert the Handle (#21) into the Gearbox Motor Assembly Mounting Frame (#19) with Support
Leg (#12) so that bolt holes line up. See Fig.4 and Parts Diagram. Insert through holes from
the Gearbox Motor Assembly Mounting Frame (#19) and front side of the Support Leg (#12)
with Bolt M10 x 70 (#18), then with Flat Washer 10 (#26), Spring Washer 10 (#27) and Nut
M10 (#13). Tighten them by hand. Repeat on other side
3. Attach the Wheel (#10) to the Front Frame (#9) and secure with Flat Washer (#25) with Cotter
Pin (#11).
Note:
The Flat Washer (#25) should be put between the Wheel (#10) and Inner
Side of the Cotter Pin (#11).
See Fig.3. Repeat on other side.
4. Secure the Gear Box Assembly (#20) to the five holes in the Gear Box Stand (#19) with Flat
Washer 5 (#33), Spring Washer 5 (#32) and Hex Nut M5 (#31). See Parts Diagram.
5. Attach the Protective Plate (#17) to the Gearbox Motor Assembly Mounting Frame (#19).
Secure with Bolt M6 x 12 (#15) and Flat Washer 6 (#28), Spring Washer 6 (#29) and Nut
M6 (#16). See Fig.2 and Parts Diagram.
6. Secure the Mixing Drum (#4) to the Gearbox Shaft (#20) with T-handle bolt assembly (#5, #6,
#7, and #8).
Tighten firmly with a wrench.
See Fig.6 and Parts Diagram.
7. Secure the mixing blades (#2) to the inner side of Mixing drum (#4) with Bolt M8 x 20 (#1),
Leather Washer (#24), Flat Washer 8 (#22), Spring Washer 8 (#23) and Nut M8 (#3). See
Fig.6.
Note:
The Leather Washer (#24) should be put between the Mixer Blade (#2) and inner
side of the Mixing Drum (#4).
8. Go back and retighten all screws, nuts and bolts after the cement mixer assembly is complete.
