12. When cutting magnesium never use soluble oils or emulsions (oil-water mix) as water will greatly
intensify any accidental magnesium chip fire. See your industrial coolant supplier for specific coolant
recommendations when cutting magnesium.
13. To prevent corrosion of machine surface when a soluble oil is used as coolant, pay particular
attention to wiping dry the surfaces where fluid accumulates and does not evaporate quickly, such
as between the machine bed and vise.
14. Stop the machine before removing chips.
15. Make all adjustments with the power off.
16. Disconnect machine from power source when making repairs.
17. Shut off power and clean the Band Saw and work area before leaving the machine.
WIRING DIAGRAM
TOGGLE SWITCH SINGLE PHASE
ASSEMBLY
t the speed directly by operating the handle beside the
ose the appropriate speed in accordance with the material of the
2. After the cut processing is completed, the power will turn off automatically.
A 1 HP, 1725 motor, split phase or capacitor-start, is recommended for best economical
performance.
The characteristics of this machine:
1. If you want to shift the speed, you may shif
gearbox. And you may cho
workpiece.
Page 4 of 15
