ENGLISH
GREAT BRITAIN • CUSTOMER SERVICE
tel. 0845 300 9799 e-mail: [email protected] internet: www.clasohlson.com/uk
5
3
4
6
7
10
9
1
2
8
Ver
. 20140528
Alfred Outdoor Lamp
Art.no 36-1425
Model EL-991DN
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right
for any errors in text or images and any necessary changes
made to technical data. If you have any questions concerning
technical problems please contact our Customer Services.
Safety
•
Warning:
All light fittings must be installed in accordance with
current safety regulations to prevent life-threatening accidents.
• The installation of this light fitting should only be performed
by someone with a good knowledge of electrical wiring.
• If in doubt, contact a qualified electrician.
• Follow the instructions carefully and keep them for future
reference.
Description
1. Glass diffuser
2. Shade
3. Wall bracket
4. Terminal block
5. Wall plate
6. Retaining screws
7. Cap nut
8. Rubber seal
9. Metal washers
10. Rubber washers
Installation
7. Connect the power lead to
the terminal block as shown below.
-
Brown or black (live) connects
to the terminal marked “L”.
-
Blue (neutral) connects to
the terminal marked “N”.
-
Yellow-green (earth) connects
to the terminal marked with
the earth symbol .
Warning:
Always turn the power
off at the distribution box before
installation (main power switch/
circuit breaker set to
OFF
, or fuse
completely disconnected).
Note:
The wall plate should be
mounted with the marked arrow
pointing upwards.
1. Remove the cap nuts (7) and rubber washers (10),
and remove the wall plate (5).
2. Measure out the area where the light will be mounted.
3. Thread the power lead through the wall plate’s rubber seal.
4. Push the retaining screws (6) through from the back of
the wall plate before screwing it onto the wall.
5. Depending on wall type, you can either screw the wall
plate directly onto the wall or mark out and drill mounting
holes and use plugs for mounting.
6.
Note:
The rubber seal (8) should be pressed securely
onto the wall plate so that it forms a seal against the wall
bracket before mounting.
8. Mount the wall bracket onto the wall plate so that its
retaining screws protrude at the front. First thread
the rubber washers (10) over the retaining screws (6), then
the metal washers (9) and finally use the cap nuts (7) on
top to tighten everything together.
9. Remove the glass diffuser and screw in a light bulb (max
60 W, E27) (sold separately). Screw the glass diffuser back
on securely and turn on the power.
Disposal
This product should be disposed of in accordance with local
regulations. If you are unsure how to proceed, contact your
local council.
Specifications
Model
EL-991DN
Voltage
230 V AC, 50 Hz
Bulb
Max 60 W, E27 (sold separately)
IP rating
IP23
Shade
Ø 30 cm
