7
II.) Assembly Instructions
III.) Pump Preparation
A.)Remove red shipping plug from oil fill hole.
B.) Install vented dipstick into oil fill hole.
C.)Make sure the oil is 1/2 way up oil sight glass.
IV.) Engine Preparation
A.) Fill engine with 1.16 qt of oil.
B.) Fill fuel tank with unleaded gasoline, 86 octane min.
Quantities Of Fluid
Engine/Pump
Type of Fluid
QTY
Honda GX390
SAE 10W30
1.16 qt (1.1L)
General TS1511
SAE 30**
40.60oz (1.2L)
**SAE Non-Detergent (Item# 4043)
V.) Battery Preparation
A.) Battery is shipped without electrolyte.
B.) Fill each battery cell to the fill line with locally
purchased electrolyte (sulfuric acid and water).
WARNING Sulfuric acid is a corrosive poison. Avoid
contact with skin, eyes or clothing.
C.) Connect battery cables to battery terminals.
WARNING To connect the battery:
Always
connect the red, “+”, or positive battery cable
first, then connect the black, “-”, or negative battery
cable.
Always
disconnect the black, “-”, or negative cable first,
then disconnect the red, ”+”, or positive cable.
LIFT BACK OF UNIT BY HANDLES TO
INSTALL REAR WHEELS, THEN LIFT FRONT
OF UNIT TO INSTALL FRONT WHEELS
INSTALL WHEEL ONTO AXLE
FASTEN WHEEL WITH RETAINER,
SECURE RETAINER WITH WRENCH PROVIDED
NOTE
: IT IS RECOMMENDED THAT TWO
PEOPLE LIFT THIS UNIT WHILE A THIRD
SLIDES THE WHEELS ONTO THE AXLES
PRESS BRAIDED HOSE ONTO
INJECTOR AND STRAINER
FASTEN HANDLES TO FRAME WITH
5/16 X 3/4” BOLTS AND 5/16 NUTS
INSTALL
TUBE CAPS
INSTALL GROMMETS
AND NOZZLES INTO
HOLES IN FRAME
FIG01007
