3
1) Open release valve and
remove the oil plug.
2) Operate pump rapidly
several times to force air out.
3) Close release valve and
replace the oil plug.
The Jack should now operate
normally. If it does not, repeat
the purging procedure as
needed.
RUST PREVENTION
Keep piston, pump, and
extension screw in full down
position when not in use. Avoid
contact with moisture. If
contact with moisture occurs,
wipe dry and grease/lubricate
all jack parts.
CAUTION:
• Read all the instructions
carefully before use.
• Never exceed the jack’s
rated capacity.
• Jack should only be used on
a solid level surface.
• Never work underneath the
vehicle without the use of
additional safety support
devices (Ex: Rated jack
stands).
• Do not disassemble.
Disassembly may result in
malfunction or injury.
3) Place jack under the
vehicle at the proper lifting
point. (Refer to Owner’s
Manual.) If needed, turn the
extension screw counter-
clockwise until it comes into
contact with vehicle.
4) Insert jack handle into
handle socket. Pump the
handle to lift the vehicle to
the desired height.
To Lower:
Caution: Lower vehicle
slowly! Turn release valve
slowly.
1) Remove handle, use
small end to open the
release valve. (To open
release valve, turn it
SLOWLY in a counter-
clockwise direction.)
Note: Do not open release
valve more than one (1)
full turn.
2) When vehicle is fully
lowered, remove jack. If the
extension screw has been
extended, turn it clockwise until
it retracts enough to move the
jack away from the vehicle.
MAINTENANCE
Adding Oil/Lubrication (Fig 5)
1) Place the jack in an upright
position.
2) Lower pump and piston to full
down position.
3) Remove the rubber oil plug
on jack.
4) Fill with a good grade
hydraulic oil only. (Fill to the
lower rim of oil fill hole.) Purge
system of air as described in
this manual.
5) Replace rubber oil plug.
6) Lubricate pivoting joints and
screw extension periodically for
proper maintenance.
PURGING AIR FROM
HYDRAULIC SYSTEM
Occasionally, air bubble
become trapped inside the jack,
reducing its efficiency. Release
air from the jack’s hydraulic
system following the directions
below.
