Nortel RLC, Installation And Administration Manual

Page: 38 / 466

12 RLC Installation and Administration Guide
RLC description Standard 4.0
The following table describes the RLC Multi-I/O cable–Basic:
The length of this cable, from the termination end of P1 to the termination end of
any other plug, is 0.6 meters (2 feet).
RLC Multi-I/O cable–Enhanced (NTDR80xx)
The RLC Multi-I/O cable–Enhanced allows you to use the RLC’s complete
functionality. In addition to the connectivity supplied by the RLC Multi-I/O
cable–Basic (refer to page 11), the RLC Multi-I/O cable–Enhanced adds
connectivity to the host PBX’s internal (or embedded) Ethernet for switch
maintenance. With the Enhanced cable you can also service locally connected
telephones through RLC ports not used for remote service purposes.
The
connector
labeled
is a that transmits and connects to the
P1 25-pair
connector
(female) all signals I/O panel.
Note: If you are using a 32-port RLC, insert P1 into the socket for the first of
the two card slots occupied by the RLC.
P2 DB-15
connector
(male) 10BaseT
signaling CLAN Ethernet
(customer LAN on the
network).
Note: P2 requires a DB-15 to RJ-45 converter (part number 301-00001-01,
shipped with the cable).
P3 DB-9 connector
(female) RS-232 signaling serial port to admin PC
for administration and
maintenance.