Nortel RLC, Installation And Administration Manual

Page: 361 / 466

RLC Installation and Administration Guide 335
June 2005 Planning forms
Reach Line Card
Connection Information—32 ports
Complete one copy of this form for each Line Card. Page 1 of 9
RLC information
IPE position: Loop:________ Shelf: _______________ Card:____________
IP address:
Subnet mask:
Default gateway:
Host PBX’s ELAN IP address:
Host PBX’s ELAN subnet mask:
Security level:
❒
No security required
❒
Caller ID
❒
Provisioned Security*
*If the security level is provisioned security , RLC’s security identifiers:
Inbound
Outbound
Notes:
„
This RLC provides 64 total ports. Ports 0–31 are Voice ports and ports 32–63 are Data ports. On
the host PBX, you must configure Network ports or Remote ports that use MCAs or ATAs (for
data transmission) as data ports. If there are not enough free data ports, you can configure
Remote ports that use ATAs as voice ports. You can configure Remote ports used for FAX
support as either voice ports or data ports. Refer to documentation for your PBX for necessary
procedures.
„
QoS Transition Technology requires one MCA per B-channel.
„
If MCAs or ATAs are to be used to transmit data, a maximum of seven MCAs or ATAs can be
connected to this Reach Line Card.