Nortel RLC, Installation And Administration Manual

Page: 107 / 466

RLC Installation and Administration Guide 81
June 2005 Installing the RLC
Installing DSP application modules
Install DSP application modules (NTDR73xx) in the expansion slots on your
RLC. This increases the number of simultaneous ports, and telephone lines, that
you can use at remote sites. To add DSP application modules to your RLC,
follow these procedures:
1 Determine the number of DSP application modules that meets your needs
using the System expansion worksheet on page 345.
2 Install DSP application modules using the procedure on page 82.
Determining how many DSP application modules to add
To determine the number of DSP application modules your RLC needs, refer to
the System expansion worksheet on page 345. For more information on how
DSP application modules fit into your Remote Gateway 9100 Series system,
refer to “DSP requirements” on page 49.
After receiving the DSP application modules from Nortel, install them according
to the procedure found under “Installing DSP application modules” on page 82.
Handling DSP application modules
Before beginning the installation and configuration process, review “General
safety” on page 78.
Follow the safety precautions and warnings found there to
protect your investment in your telecommunications network.
.
CAUTION
Risk of data loss or equipment damage
Be certain you are properly grounded before handling DSP
application modules or the RLC.